For even deeper wells, The ADP-10510 is
capable of pumping up to 150 feet from ground level by simply connecting the
pump to our revolutionary Low Flow With Power Booster II Controller, or Power Booster II Controller (controller sold separate).
Note: These controllers increases 12 volts to a constant 24 volts.
In return, the ADP-10510 will make your next groundwater sampling event go much quicker when it comes to purging a well. And with the Low Flow With Power
Booster II Controller, the field technician now has the ability to control the flow of water being discharged from the ADP-10510 thus, keeping up with EPA groundwater standards for Low Flow Sampling.
The ADP-10510 reliable design is suitable for continuous sampling or purging of groundwater wells. Simplify and Expedite Your Next Sampling Event!
The ADP-10510 can pass sand, small rocks and debris without getting clogged or damaging the pumps motors!
The ADP-10510 can run continuously without the need for a cool down!
The ADP-10510 can also run dry for up to 2 hours without motor damage!
The ADP-10510 has a 400 hour motor life!
The ADP-10510 has a sleek outside that minimizes well hang-ups.
The ADP-10510 is a very reliable and economical pump that provides a great bang for your buck!
The ADP-10510 comes ready for field use; For your convenience the ADP-10510
comes complete with a sturdy polymer reel along 160 feet of heavy duty wire and Power Booster II adapter and it is shipped in its own box.
SPECS:
POWER CONSUMPTION:
360 WATTS (MAX)
VOLT RECOMMENDATION:
12-15 At Source
MAXIMUM AMP OUTPUT:
15 AMPS
MEASUREMENTS:
LENGTH 24” / DIAMETER: 1.8”
CONSTRUCTED:
PVC PLASTIC & STAINLESS STEEL
DISCHARGE OUTLET:
3/8" ID x 1/2"ID (WITH BARBED TIP ENLARGER)
SUPPLIED WITH:
160 FEET OF HEAVY DUTY 10 GAUGE WIRE, WITH THREE PRONG MALE ADAPTER AND MOUNTED ON A HIGH IMPACT PLASTIC REEL
